American driver bowin down to porsche drivers...

[T88TurboStang]

Hey eveyrone, i know i am a mustang american dude, and i should not belong here, but i am just here to say that you guys kick major ahss. I think porsche is the most insane company out there along with audi, mercedes, and bmw. YOu germans are crazy.

I was driving one day, and i rolled up to this yellow GT2 porsche. Well me not being scared at all since i almost have 600 rwhp in my stang, i thought this would be a little fun to literally give the Porsche driver a run for his money....22k vs 150k....! Well we both took off, and OMG he had me of the line, i waited till my single T88 to spool up and once it did, it took me to about 80 mile per hour to literally pull a car length on that fuvker, i must say the thing stock out of the factory had me pretty freaken good. With the rear motor, 456 hp twin turbo, lightweight two wheel drive bastard is ungodly fast.

I want to here in front of all of you BOW DOWN, and kiss the feet of all porshce drivers, you really invested in the best!!!

[wee man]

Any Porsche would beat any Mustang :roll: :roll: Mon The Porsches!!!!!!!!

[T88TurboStang]

Haha, well not my baby....lets just say that i have given porsche dirvers, literally, "A RUN FOR THERE MONEY"....muahahahaha

[GIR]

Uhu and I presume you got a video to prove this to us?

[thepolarfoxqx]

A Cobra can take on - and beat a porsche 911 carrera, a saleen or rousch cobra can take on a 911 turbo.

I've seen it.

[T88TurboStang]

Originally Posted by GIR Uhu and I presume you got a video to prove this to us?

SURE.... how do i host though????

[izzyloveslizzy]

I think you can upload the video to the site, T88. I'd like to see this too. Also, would you mention the stats on your 'Stang again?

[T88TurboStang]

Originally Posted by izzyloveslizzy I think you can upload the video to the site, T88. I'd like to see this too. Also, would you mention the stats on your 'Stang again?

ITs a

sean hyland long block,
-billet rods, pistons, lobe cams, titanium valve springs, frpp fr500 heads, fully built motor, cost me 6gs for that beyatch,Hooker ceramic coated long tube headers, Bassani X pipe w/cats and cat-back system, Steeda pulley's, Fidanza aluminum flywheel, KB Matrix system, drive shaft saftey loop , Pro 5.0 shifter, MM caster/camber plates, Canton oil pan, Autologic custom chip, Superior 31 spline axles and Eaton posi rear.

-i was originally going with a T76 turbo, but i opted to go with T88 becuase i thought the lag was too bad, so the 76 would be better, but the motor and the torque of it, the T88 would do just fine. It is a single Turbo. but the fun part of it is the HOGANS direct port intake manifold.

-T56 6 speed tranny, aluminum driveshaft, 31 spline axles, rear panhard bar, 410 gears, (fun suspension goodies)

-bilstein shocks struts, rear control arms, sway bar and end link kit, etc, etc.....

When i first was driving the car, i dynoed it around 460 rwhp, and 488 rwtq. This was on a moderate amount of 12lbs of boost. Lalty, i have bumped it to around 17-19 psi depending on what my chips selfprogramed boost link will allow. But when i ran the highest boost i could for now, i ran somwhere in the 593 rwhp, and 570 rwtq. I dont konw why my torque peak was so low, but i am hopin with a one more dyno tune, i can fix it. A dyno jet got me lower numbers than the other dyno.

I have a video of when i first got it done, it is just me drivin by the camera. I want to go to local drag strip, and hopefully my buddy can get me hooked up with a better vid.

GIR Posted: Thu Apr 03, 2003 6:37 pm Post subject: -------------------------------------------------------------------------------- Uhu and I presume you got a video to prove this to us?

BUt as for your comment goes, this is the internet, and i have learned that i really dont take any comments said seriously, you just have fun with what you got, nad i will have fun with mine.

If not, i gotz a 92 stang with a 351 windsor, lol bought that crap for 900 bucks, OMG hte guy was such a dumbass. Best time though in that thing was a 13.1 at 105....

gotta stop hittin da herb, my Reaction times are like .9 haha!!!

[izzyloveslizzy]

Originally Posted by T88TurboStang ... and i have learned that i really don't take any comments said seriously, you just have fun with what you got, and i will have fun with mine....

Well, I'd still like to see the videos, gentlemen.

[thepolarfoxqx]

I'd like to see what you could do with the 351 Windsor Stang!!!

You can upload your images to the gallery.

I look forward to seeing.

By the way, how big are your tires out back to put that much down?

(how do you keep axle hop in check?)

That car sounds like an absolute beast.